My CLI� handheld does not work properly
I cannot turn on my CLI� handheld
B Is the POWER/HOLD switch of your CLI� handheld in HOLD mode? Your CLI� handheld does not work when the POWER/HOLD switch is in HOLD mode. Make sure you release HOLD mode.
Note If you press the application buttons, Data Assistant button, or CAPTURE button, or slide down the VOICE REC switch, or open the camera lens cover during HOLD mode, the POWER LED blinks 3 times. However, your CLI� handheld does not operate.
B Has the battery power of your CLI� handheld run out? Connect your CLI� handheld to the AC power adapter with the plug adapter, then allow it to be charged for a few minutes before turning it on. If it turns on, continue charging for approximately five hours and then perform a soft reset by pressing the RESET button of your CLI� handheld. b For details, refer to �Basic operations of your CLI�� handheld: Restarting your
CLI�� handheld� in the supplied �Read This First (Operating Instructions)�.
B Is the connector between your CLI� handheld and the plug adapter dirty? You cannot charge your CLI� handheld if the connector is dirty. Connect and disconnect your CLI� handheld and the plug adapter several times to clean the connector. B Perform a soft reset by pressing the RESET button of your CLI� handheld. b For details, refer to �Basic operations of your CLI�� handheld: Restarting your
CLI�� handheld� in the supplied �Read This First (Operating Instructions)�.
The screen is not displayed even though the POWER LED is on
B Is the POWER/HOLD switch of your CLI� handheld in HOLD mode? The screen is not displayed when the POWER/HOLD switch is in HOLD mode. Make sure you release HOLD mode.
