|
|
|
Usuarios conectados
Actualmente hay 6043 visitantes online. |
|
Productos
|
|
Información
|
|
Destacado
|
|
|
 |
|
- GENERAL
- Location of Controls
- Getting Started
- Setting the Clock
- Cassette Player
- Radio
- RDS
- Other Functions
- CD/MD Unit
- Connections
- DISASSEMBLY
- Cover
- Front Panel Assy
- Sub Panel Assy
- Mechanism Deck
- Main Board
- Heat Sink
- ASSEMBLY OF MECHANISM DECK
- Housing
- Arm (Suction)
- Lever (LDG - A)/(LDG - B)
- Gear (Loading FT)
- Guide (C)
- Mounting Position of Capstan/Reel Motor (M901)
- MECHANICAL ADJUSTMENTS
- ELECTRICAL ADJUSTMENTS
- Tape Section
- Tuner Section
- DIAGRAMS
- Block Diagram - Tape Section
- Block Diagram - Tuner Section
- Block Diagram - Main Section
- Printed Wiring Boards - Main Section
- Schematic Diagram - Main Section
- Printed Wiring Board - Display Section
- Schematic Diagram - Display Section
- IC Pin Description
- EXPLODED VIEWS
- Chassis Section
- Front Panel Section
- Mechanism Deck Section
- ELECTRICAL PARTS LIST
No hay comentarios de productos.
TUNER SECTION
Cautions during repair
0 dB = 1 µV
When the tuner unit is defective, replace it by a new one because its internal block is difficult to repair.
FM Auto Scan/Stop Level Adjustment Setting : SOURCE button : FM FREQUENCY SELECT switch (C8100) : FM 200K
FM RF signal generator antenna terminal
TEST MODE
This set have the test mode function. In the test mode, FM Auto Scan/Stop Level and AM (MW) Auto Scan/Stop Level adjustments can be performed easier than it in ordinary procedure. <Set the Test Mode> 1. Set the �OFF� mode. 2. Push the preset 4 button. 3. Push the preset 5 button. 4. Press the preset 1 button for more than two seconds. 5. Then the display indicates all lights, the test mode is set. <Release the Test Mode> 1. Push the OFF button. Note on Adjustment The adjustments of tuner section, should be performed according to the following sequence. 1. FM Auto Scan/Stop Level Adjustment 2. FM Stereo Separation Adjustment (WIDE) 3. FM Stereo Separation Adjustment (NARROW) 4. FM RDS S-Meter Adjustment (XR-C8100R only) 5. AM (MW) Auto Scan/Stop Level Adjustment
0.01 µF
Carrier frequency : 97.9 MHz (C8100) 98.00 MHz (C8100R) Output level : 22 dB (12.6 µV) Mode : mono Modulation : 1 kHz, 22.5 kHz deviation (30%)
Procedure : 1. Set to the test mode. 2. Push the SOURCE button and set to FM. Display
SHUF
*1
*2
REG
3. Push the preset 3 button. Display
SHUF
*1 *2
REG
4. Adjust with the volume RV2 on TUX10 so that the �FM� indication turns to �FM0� indication on the display window. But, in case of already indicated �FM0�, turn the RV2 so that put out light �0� indication and adjustment. Display
SHUF
*1 *2
REG
*1 : XR-C8100R has the �98.00� displayed. *2 : �REG� is displayed only for XR-C8100R. Adjustment Location : See page 28.
� 25 �
|
|
|
> |
|
